2-Channel Isolated CAN FD Expansion HAT for Raspberry Pi
Opis
This is a 2-Channel CAN bus expansion HAT designed for Raspberry Pi, supports CAN FD (CAN with Flexible Data-Rate), up to 8Mbps data rate, features multi onboard protection circuits, high anti-interference capability, and stable operation. It suits for fields such as automotive devices or industrial automation.
This HAT will enable CAN bus for your Raspberry Pi, not only the original CAN 2.0 protocol, but also the CAN FD extension, with up to 8Mbps data rate, and higher data throughput.
Thanks to multi onboard protection circuits, include 500W lighting surge, ESD, short circuit protection, and electrical isolation, it make the communication more safe and more reliable.
- Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
- Supports both traditional CAN2.0 and CAN FD protocols, up to 8Mbps data rate
- Breakout SPI control pins, for connecting with host control boards like STM32/Arduino
- Onboard electrical isolation, up to 5KV isolated voltage, high anti-interference capability, stable operation
- Onboard lighting proof, ESD, short circuit protection, more safe communication
- Onboard voltage translator, select 3.3V/5V operating voltage by jumper
- Onboard 120Ω terminal resistor, configured by jumper
- Comes with development resources and manual (examples for Raspberry Pi/Arduino)
- CAN controller: MCP2517FD
- CAN transceiver: MCP2562FD
- Communication interface: SPI (two channels independent SPI by default, swith to one channel SPI by soldering)
- Power supply: external power input terminal, or Raspberry Pi
- Power input terminal voltage: DC 8~26V
- Operating voltage: 5V
- Logic level: 3.3V/5V
- Dimensions: 65.0 x 56.5 mm
- MCP2517FD CAN controller
- MCP2562FD CAN transceiver
- SI8642ED digital isolator
- MP1584EN power chip
- RT9193-33 power chip
- B0505LS-1W power supply isolation module
- Raspberry Pi GPIO connector: for connecting Raspberry Pi
- CAN terminal
- External power input terminal: DC 8~26V input
- MCU control pin: for connecting with host control boards like Arduino
- 120Ω terminal resistor configuration
- 3.3V/5V logic level selection
- CAN operating mode selection:
A: CAN_0 and CAN_1 use two channels independent SPI (default)
B: CAN_0 and CAN_1 share one common SPI - Power indicator
- 2A fast auto-recovery fuse
- Power supply anti-reverse diode
- Power supply anti-countercurrent diode
- Follow current diode
- SM24CANB TVS diode array
Dodatkowe informacje, instalacja oprogramowania, sposób konfiguracji itp : Wiki : www.waveshare.com/wiki/2-CH_CAN_FD_HAT